FW now in Ready state [ 1. Understand that you should only use caching if you have good UPS power to the system. It fixed a problem with the bbu on one which had very old fw it turned out. Email Required, but never shown. The system board must support Interrupt 15 memory allocation.
|Date Added:||24 September 2007|
|File Size:||30.86 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Please change the filenames to match your versions etc.
It has to be able to allocate memory during boot up or the driver will not initialize. Views Page Discussion View source History. Has anybody gotten this card to work, or a related model? After that, the ubuntu drivers loaded correctly and my ubintu were available from the os. Email Required, but never shown.
I’ve been through dmesg twice entirely and cannot see anything suspicious that could be related. I’ve tried to install Ubuntu Add the following lines to the end of the last line in the startupui.
Installing LSI MegaRAID Storage Manager on Ubuntu 16.04 64 bit Desktop
Physical Drives – Physical Hard Disks attached to controller, represented by id, 9260-8k etc.
I checked the firmware version and it is quite outdated. I think you meant setting up a password for root is NOT a best practice, and I agree. Uubntu a Reply Cancel reply Your email address will not be published. It means actually raid 0 over raid 1 that is RAID Does anyone have a suggestion? I start to think that there is an incompatibility between the motherboard ksi these RAID contollers. LSI MegaRaid i with 8 disks attached. We can see here Primary raid level 1 and secondary 0.
You need to install drivers for the RAID controller. Lets look at each cache policy LSI raid card use. Thanks for your answer Daniel B.
ubuntu – Hardware RAID not recognized by OS – Super User
Sign up using Email and Password. Post as a guest Name. There might be related messages before or after. FW now in Ready state [ 1. We can see configurations in megacli like Virtual Drive with RAID 0 over one physical drive, we have this settings because physical drives attached to raid controller, and for representing the device to the system we must set it in megacli. It no longer looks to be in the Ubuntu repo? MegaCli not providing all the information we need like mapping to linux devices and raid level readableso we are going to use some extra tools.
Thanks for your comments. This controller should work fine with Linux according to here.