Then I tried it on my laptop both running WinXP and that worked too. The posting of advertisements, profanity, or personal attacks is prohibited. Click here to review our site terms of use. Only after the test is passed do you solder in the jumper that will attach the 5v power rail to the USB chip. Oh sorry you need to buy an entirely new programmer for that with all new system modules. With a starting base of over devices supported and Windows based software this programmer is a great renovation of the EMP

Uploader: Mimuro
Date Added: 9 July 2009
File Size: 62.83 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 71106
Price: Free* [*Free Regsitration Required]

Where is the windows version?

Supporting over devices and Windows-based software, the programmer’s ‘automated one touch’ system allows the user to blank check, erase, program, verify or any combination of these functions by simply pushing a button. Verify error at location uusb Needhams has since gone out of business].

If worst came to worst, you could splice two cable ends together. High cost, high value equipment, acquired from a reliable source!

Device Programmer

The good news was that the software correctly recognized the ‘ after I plugged it in correctly, but this is a negative as well. You can click the image to get a larger view. Getting the Kit As you can imagine this is a “kit” which is short for “some assembly required.

New Drivers  57XX GHOST DRIVER

The programmer, parallel and usb cable, transformer, and Family Modules, together weigh in at less than five pounds! The good news is that I now have a programmer that can program a wide emp2 of Microchip PIC devices that communicates with the host computer via USB. Your message has been reported and will be reviewed by our staff.

Fortunately the surface mount USB chip is already soldered to the board. So a proper fill is done by pressing the button.

I’ve been programming PIC microprocessors from Microchip from the beginning. This proceeded without error and I was quite pleased with myself until I tried to verify the program. Also the default color.

Device Programmer Refine Results. Also in later revs one of the crystals was changed to 6Mhz from 4Mhz so I needed an extra crystal.

At least 40 Mb of free space is required and interface is via the USB port, or a standard parallel port. Choose Yes and wait for the light to change from yellow to green. When the Device programmer search screen appears, press the OK after you match the settings with the figure above. It was missing one component a 47uF Electrolytic capacitor which I replaced from my own parts stock.


They have been used in other programmers from time to time, to inexpensively route power and ground to the device. This page was last updated: Verify error at location 0x If the default settings are in place the software should automatically verify that epm21 is in the chip matches the buffer.

Chip Programming Instructions

Once the kit is assembled, and before the chips are installed, you apply power and measure for 5V on a pair of convenient test points.

Once that’s done I’ll post here on my website for others to use. Does not include any interface modules. Return to the notebook.

This board uses an “A” USB connector to connect to the programmer. Be aware of the e,p21 goods coming from China. RED for a failure during programming. It was missing one component a 47uF Electrolytic capacitor which I replaced from my own parts stock.

Author: admin