All settings gave memtest errors in test 6. Packard Bell case hoping to upgrade to http: As the memory is supposed to run Mhz at 1. Plenty of people using this memory on the UD3P board with good results. The BIOS default settings for the memory is 5 5 5 I only tried it at fsb 2:
|Date Added:||17 June 2016|
|File Size:||45.90 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
ASUS DRW 2014 LIT DRIVERS
I then did the same tests but added 0. Does this definitively point to a problem with memory. Tweaked a few settings which I won’t go into just yet and then Prime95 blend tests ran for just on 4 hours without error before getting application hang not BSOD.
I won’t go into the actual settings I used just yet, more on that later.
Win7 64 ,w psu,seasonic This is similar experience I had with my first build with crucial memory. Data-CD Testing – 7: I only tried it at fsb 2: If only I would have looked a asu closer at burning times. I think you will be just fine going with that brand.
ASUS DRWL1T DVD±/RW DRIVE with LightScribe Review – Page 13
Maybe it needs more? Images with the largest diameters will take longest to burn. All settings gave memtest errors in test 6. Plenty of people using this memory on the UD3P board with good results. Build went well, nice case and the Xigmatec cooler shaves about degrees off CPU drw-2104lit on the E compared to the Xeon in my other build.
Good luck with the setup, hope all goes well!
SKills which have a good reputation on Gigabyte boards. You might remember me with the problems I had with my crucial tracers 2. Only LightScribe media has this special coating and as mentioned before, this makes Lightscribe media more expensive.
memory for EPUD3P
It is actually pretty impressive to see and you can make some interesting labels but it does take quite a bit of time and the media is more expensive. Sorry, I personally have dfw-2014lit tested those in UD3 boards, but I have not seen any issues or normally about the same as long as it is quality ram. I didnt think I would need to tweak all the memory settings to get the memory to run stable at stock speed, or do I? The E idles at about degrees, both cores too, my has a 12 degree temp difference between the cores at idle.
But memtest gives errors at 2. Crucial would be fine on your P45 I know how you feel though, but it is ok for sure now especially the 2.
I did read those reviews on Newegg newegg reviews are great for getting a general idea of what seems to work and what doesn’t, aren’t they. Want to know why?
Drw-2014lot gx Win7 64 ,w psu ocz Mushkin seem to be pretty hard to get where I am, so I was looking at G. I know any memory can fail and there are compatability issues asuus BIOS tweaking that needs to be done, but has anyone used the G. I’m looking at memory, maybe I should just go with where I’m likely to have less problems.
Later that day the machine rebooted during a run of Prime95 blend tests, probably minutes after I started the test. Audio-CD Testing – 8: But most people using the PI series G. Once again I’m open to suggestions. HP cooler 8GB Gskill ripjaw ddr